Adderini - What you need?
Detailed instruction on how to make the Adderini Pistol can be found in the file:
Adderini_Pistol.pdf
Read it all before you start doing anything! Make sure you have the latest version of this file.
To build Adderini Pistol bow you must have:
- FDM 3D printer with a heatbed of at least 200 x 200 mm
- about 0.6 kg of PLA filament
- 8 pieces of M3x35 mm screw
- 16 pcs. M3x20 mm screw
- 2 pcs. M3x16 mm screw
- 5 pcs. M3x12 mm screw
- 4 pcs. M3x6 mm screw
- 2 pcs. M4x40 mm Allen screw
- 3 pcs. M3x16 mm grub screw (headless set screw)
- 24 pcs. M3 nut
- 2 pcs. M4 nut
- 1 piece of steel spring with a diameter 8 mm, length 20 mm and wire diameter 0.8 mm
- 1 piece of steel spring with a diameter 8 mm, length 20 mm and wire diameter 1.0 mm
- 1 small steel spring (from a clicky pen) with a outer diameter 4.2 mm, length 20-25 mm
(half of the spring for magazine_pivot_lock and half for cocking_lever_lock)
- TheraBand Gold rubber band 130x128mm, circular blade knife
- about 2,5 m polyester bowstring, serving thread, bowstring wax
- precision files, 180-240 sandpaper
- wrenches, screwdrivers, sharp knife, lighter, clamp, clothes pegs
- CA gel glue or two-component epoxy adhesive (for gluing parts)
- PTFE grease
Below are links to buy some hardware parts that are necessary to build and use Adderini. These are not affiliate links and are only intended to help you find the right parts.
If you know proven sources in your country, please send me links to them by email and I will try to put them here to help others.
Complete Hardware Kit
DE (worldwide shipping),
